NordicTrack NTL07707.2 User Manual page 9

7. Set the console assembly face down on a soft
surface to avoid scratching the console assem-
bly. Hold the Right Handrail (95) near the con-
sole assembly. Next, insert the console wire into
the large hole in the Right Handrail and out of
the top as shown. If necessary, use needlenose
pliers to help pull the console wire out.
Attach the Right Handrail (95) and the Left
Handrail (not shown) with four #8 x 3/4" Screws
(1) (two are shown). Make sure that no wires
are pinched. Start all four Screws before
tightening any of them; do not overtighten
the Screws.
8. Tighten a 1/4" x 1 1/4" Bolt (5) with a 1/4" Star
Washer (33) into the bracket and Handrail
Crossbar (94) on each side of the console as-
sembly (only one side is shown).
Remove the wire tie from the console wire.
9. Remove the long tie from the Upright Wire (38).
Have a second person hold the console assem-
bly near the Right Upright (78) and Left Upright
(not shown). Connect the Upright Wire (38) to
the console wire. See the inset drawing. The
connectors should slide together easily and
snap into place. If they do not, turn one connec-
tor and try again. IF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
Attach the console assembly to the Right Upright
(78) and Left Upright (not shown) with four 5/16"
x 3 1/4" Bolts (7) and four 5/16" Star Washers
(10) (only two are shown). Be careful not to
pinch the wires.
See steps 4 and 6. Tighten the four 3/8" x 5"
Bolts (6).
7
1
95
8
Console
Assembly
9
Console
Assembly
Console
Wire
78
7
9
Console
Wire
Hole
1
Console
Assembly
5
33
94
Console
38
Wire
Long
Tie
10
38
Wire
Tie