HP ProBook 4520s Maintenance And Service Manual page 131

e.
f.
g.
h.
i.
Remove the power connector assembly:
1. Position the computer right-side up with the right side toward you.
2. Disconnect the cable from the system board (1) and remove the tape and cable from the routing
channel in the base enclosure.
3. Lift the power connector (2) from the base enclosure.
Reverse this procedure to install the power connector.
Downloaded from LpManual.com Manuals
Thermal shield (see Thermal shield on page
Display assembly (see Display assembly on computers with 17.3-in displays on page 89
Display assembly on computers with 15.6-in displays on page
Palm rest (see Palm rest on page
Hard drive (see Hard drive on page
Top cover (see Top cover on page
67)
84)
87)
103)
Component replacement procedures 121
96)
or