Wall Controller Connections; Local Input Module Connections - Bose ControlSpace AMS8 Safety Instructions & Installation Manual

3.6 CS-WC connections and settings
3.7 CS-LIM connections and settings
4
1. Termination jumper, see NOTE in chapter 3.5
2. RS485 connector
3. Power supply connector (12-24Vdc)
4. Firmware update connector
NOTE: See Annex B. Wallpanel mounting instructions
3
1. The CS-LIM is equipped with a microphone gain adjuster, also accessible from the frontpanel by using a '0'
screw driver. Turn the adjuster anti-clockwise (seen from the front) to decrease the gain to a minimum of
32dB. Turn the adjuster clockwise to increase the gain to a max of 66dB. The factory gain setting is 38dB.
2. To change the CS-LIM from stereo to mono, this jumper needs to be set. In a mono configuration,
the audio cable should be connected to the LEFT output (jumper is left open).
3. To activate a voice EQ (optimized EQ for speech) for the microphone input,
the jumper needs to be moved from FLAT to VOICE
voice
= flat response
flat
4. Stereo, balanced line output connector.
5. Power supply connector (24Vdc).
NOTE: See Annex B. Wallpanel mounting instructions
1 2
2 5
voice
= voice EQ
flat
3. System Installation
3
4
1
15