Stanley STPP7502 Original Instructions Manual page 8

ENGLISH
Features
This tool includes some or all of the following features.
1. On/off switch
2. Lock-off button
3. Shavings discharge outlet
4. Shavings discharge outlet selector
5. Planing depth adjustment knob
6. Planing depth graduation
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Replacing the cutting blades (fig. A)
The cutting blades provided with this tool are reversible.
Replacement cutting blades can be obtained from your local
retailer.
Removing
• Loosen the bolts (7) using the spanner supplied.
• Slide the blade (8) out of the holder.
• Reverse the blade so that the unused side comes in
position. If both sides are worn, the blade must be
replaced.
Fitting
• Slide the blade into the holder until it is against the end
stop.
• Tighten the bolts using the spanner supplied.
Warning! Always replace both cutters.
Adjusting the depth of cut (fig. B)
The depth of cut is indicated by the marking (9). The setting
range can be read from the graduation (6).
8
(Original instructions)
•
•
Fitting and removing the parallel fence (fig. C)
The parallel fence is used to for optimum control on narrow
workpieces.
•
•
•
•
Note: The parallel fence should be below the planer when
installed correctly.
•
Connecting a vacuum cleaner to the tool (fig. D)
An adaptor is required to connect a vacuum cleaner or dust
extractor to the tool. The adaptor can be purchased from
your local STANLEY retailer.
•
•
Fitting the shavings collection bag (fig. E)
The shavings collection bag is particularly useful when
working in confined spaces.
•
•
Turn the planing depth adjustment knob (5) to the
required depth of cut.
Turn the knob to the 'P' postion whenever the tool is not
in use.
Thread the knob (11) into the hole on the side of the
planer and securely tighten.
Loosen the parallel fence adjustment knob (10).
Slide the parallel fence into the desired position.
Securely tighten the parallel fence adjustment knob.
To remove the parallel fence proceed in reverse order.
Slide the adaptor (12) over the shavings discharge outlet
(3).
Connect the vacuum cleaner hose (13) to the adaptor.
Slide the connecting plate (14) of the bag over either
side of the shavings discharge outlet (3).
To prevent chips from coming out opposite side of
shavings discharge outlet, move the shavings discharge
outlet selector (4) to the opposite side from the bag.