Set-Up And Usage - Razor Powerwing Owner's Manual

set -UP AnD UsAge
q Attaching the Foot Platforms
1
Using two (2) 5 mm Allen
wrenches, remove the two coupling
bolts from the frame.
4a
If necessary, use a mallet /
hammer to tap the two coupling
bolts until they are all the way
through the platforms.
q Attaching the Handlebars
1
Place the handlebar stem on the
front fork.
2
Position the right and left foot
platforms up to the frame and align
holes.
4b
The platforms should now be
snug against the frame.
2
Using a 5 mm Allen wrench
to tighten the two (2) bolts on the
collar clamp. The collar clamp
is properly tightened when the
handlebars cannot be twisted out
of alignment with the front wheel.
Make sure the handlebars are in
line with the front wheel before
tightening the bolts all the way.
3
Re-insert the two coupling
bolts removed in Step 1. Starting
underneath with the bolt on the
back. Turn product over and insert
the next set of bolts. Tighten using
two (2) 5 mm Allen wrenches.
3
Note:
The cable assembly from the
handlebar must not wrap around the
handlebar stem (as shown in Step
2). Sharp bends or twisting of the
brake cable can cause the brake to
malfunction.