Set-Up And Usage Instructions; Attaching The Seat - Razor Flashrider 360 Owner's Manual

ASSEMBLY AND SET-UP
q Attaching the Seat
Required Tools: (2) 5mm Allen wrench
1
Using (2) 5mm Allen wrenches,
remove the (4) coupling bolts from
the frame.
SET UP AND USAGE INSTRUCTIONS
q Replacing the Spark Cartridge:
Friction during sparking will eventually wear out the replaceable cartridge and cause the scooter to stop making
sparks. Worn out cartridges should be replaced.
1
Using your thumbs, press tabs
on both sides of the cartridge to
release from the bracket. Slide
cartridge away from you and
remove from bracket.
q Using the Spark Handle
1
Pull back on the Spark Handle to operate
sparking feature.
2
Align the (4) holes in seat
with the (4) holes in frame. Insert
coupling bolts through the top and
bottom of the frame.
2
Place a new cartridge in back of the bracket making sure to align the slots
on the cartridge with the two legs of the bracket. Slide cartridge forward
until you hear a click and the thumb tabs are locked in place.
NEVER push down directly on the Spark Bar, Spark
Cartridge or Spark Cartridge Cover itself.
3
Tighten the coupling bolts using
(2) 5mm Allen wrenches.
5
WARNING: Do not
attempt to replace cartridge
immediately after riding as
cartridge will be hot. Handle only
when cool.
WARNING: Keep fingers
clear of Spark Bar hinge.
WARNING: Pulling
the Spark Handle upwards too
strenuously may cause loss of
control.
NOTE: Sparks and Spark
cartridge life will vary based on
the amount of pressure applied
by Spark Handle, the length of
time pressure is applied and
the smoothness of the riding
surface.