Table of Contents
Advertisement
English
Problem
The shaver does
not work when I
press the on/off
button.
Possible cause
Long hairs obstruct the
shaving heads.
The Jet Clean System
has not cleaned the
shaver properly, because
the cleaning fluid in the
cleaning chamber is soiled
or the cleaning fluid level is
too low.
The rechargeable battery
is empty.
The travel lock is activated.
The shaving unit is soiled or
damaged to such an extent
that the motor cannot run.
In this case, the shaving unit
symbol, the tap symbol and
the exclamation mark flash.
Solution
Clean the shaving
heads by following
the steps of the
extra-thorough
cleaning method (see
chapter 'Cleaning and
maintenance').
Clean the shaver
thoroughly before
you continue shaving.
If necessary, clean
and refill the cleaning
chamber (see
chapter 'Cleaning and
maintenance').
Recharge the
battery (see chapter
'Charging').
Press the on/off
button for 3 seconds
to deactivate the
travel lock.
Clean the shaving
unit or replace it (see
chapters 'Cleaning
and maintenance' and
'Replacement').
Advertisement
Table of Contents
