Set Up The Accessory Handsets - Uniden Elite 9145 Owner's Manual

Set Up the Accessory Handsets

Install and Charge the Battery
1. Unpack all handsets, battery packs, and battery covers.
If you need to remove a cover, press in on the notch
and slide the cover down and off.
2. Line up the battery connector with the jack inside the
handset; the connector only fits one way.
3. Push the connector in until it clicks into place; tug
gently on the wires to make sure the battery is securely connected.
4. Replace the battery cover and slide it into place.
Connect the Charger
1. Use an AC adapter to connect the power jack on each charger to a
regular indoor (240V AC) power outlet.
2. Place each handset in a charger with the display facing forward. If the
display doesn't light up, reseat the handset or connect the charger to
a different outlet.
#
Charge all handsets completely (about 15 hours) before using.
Test the Connection
Pick up each handset and press
and the display should say Talk.
If there is noise or static, see page 33 for tips on avoiding interference.
Attaching the Belt Clip
Line up the holes on each side of the handset. Insert the belt clip into
the holes on each side of the handset. Press down until it clicks.
To remove the belt clip, pull either side of the belt clip to release the
tabs from the holes.
Elite9145om_20110115.indd 5
. You should hear a dial tone
HOMe/flasH
5
28/9/11 12:14:24 PM