Registering Repeaters To The Base - Uniden Elite 9145 Owner's Manual

Registering Repeaters to the Base

If you are having trouble with a repeater or if you want to replace one,
you need to register the repeater to the base.
#
Connect the repeater close to the base for easy access to the
necessary buttons and indicators. Locate the repeater in the desired
position after registration is complete.
1. On the base, open the menu and select
2. On the back of the repeater
registration button until the
2 seconds).
3. Release the button and wait for the
(this can take about 90 seconds). The repeater has been registered to
the base.
If...
the light
lINk
won't turn on
the light
lINk
continues
flashing
Only register one repeater at a time. If more than one repeater is in
♦
registration mode at the same time then they can interfere with each
other.
Only register a repeater to one base at a time. If more than one base
♦
is in registration mode at the same time then you can't control which
base the repeater registers to.
If you want to register two or more repeaters to this base, just repeat
♦
these steps with the second repeater.
Elite9145om_20110115.indd 37
you want to register, press and hold the
lINk
Try...
checking the repeater's AC adapter
x
connecting the adapter to a different outlet.
x
disconnecting the unit's AC adapter. Wait about ten
x
seconds, then try again.
making sure there are not already 6 repeaters registered
x
to this base.
making sure no other base or repeater is in registration
x
mode.
Register Accy.
light on the front starts to blink (about
light to turn on and steady
lINk
37
28/9/11 12:14:51 PM