Related Manuals for Vax bubble vs-21
Summary of Contents for Vax bubble vs-21
- Page 1 easy guide Please read carefully before using your VS-21. Always VS-21 fully extend mains cable before use.
- Page 2 Important information - Save these instructions Congratulations on the purchase of your VS-21 cylinder cleaner. In order to get the best performance from this product please read and retain these instructions. When using electrical appliances, in order to reduce the risk of fire, electric shock, and/or injury to persons, basic safety precautions should be followed, including the following:- •...
- Page 3 Fig.1a Slide the tool holding bracket over the end of the tube and tighten with a screw driver. Vax recommends positioning the bracket approx 16cm from the tube base as illustrated in fig. 1a. This allows the bracket to be used in the tool park function (explained in fig’s 11 and 12).
- Page 4 How to use your VS-21 Adjusting the cleaning tool for carpets & hard floors fig 3. Hard floor position (tiles, parquet floors, etc.) – The floor tool’s brush must be in the lower position. Press on the rocker switch to lower it. fig 4.
- Page 5 How to use your VS-21 Fully extend the mains cable and plug it into a standard domestic outlet. fig. 5 Press the power button to start the vacuum cleaner. To stop it press the button again. fig. 6 Press the cable rewind button to recoil the mains cable. fig.
- Page 6 How to use your VS-21 Fig. 8 Vacuum power can be adjusted electronically by rotating the variable power control Using the tools Fig. 9 The combination tool is stored on the cleaning tubes (fig. 9a). The tool is designed for use as a crevice tool and a dusting brush.
- Page 7 How to use your VS-21 Fig. 10 If you wish to pause briefly during vacuuming i.e. to move a piece of furniture or a rug, use the special parking position on your vacuum cleaner. Slide the hook attached to the floor cleaning tool into the slot on the rear of the appliance.
- Page 8 How to care for your VS-21 Your appliance is bagless. If you notice that the vacuum cleaner seems to be less efficient than usual, check to see if the dust vessel needs emptying. To empty the dust vessel Turn off the appliance and unplug it. Press the vessel release button on the handle (fig.
- Page 9 To change the filters There are three types of filter on your VS-21. Vax recommends changing all filters every 6 months or when a loss of suction is experienced. 1. Air outlet filters Fig. 15 The filter is located in a compartment on the side of the machine body. Remove the grill which secures it and replace the filter with a new one.
- Page 10 To change the filters continued 3. Dust vessel filter Fig. 17 Disconnect dust vessel from vacuum. Remove the filter and rubber seal assembly from the holding frame and replace with a new filter. Attention: Do not use the vacuum cleaner without the dust vessel filter, motor protection filter or air outlet filter.
-
Page 11: Replacement Parts
Replacement parts VS-21 filter pack Pack containing 2 complete filter sets, part number 1-9-124974-00. - Page 12 If you have queries or concerns about using your VAX, call the HELPLINE. Calls are charged at the UK national rate. Please make a note of the serial number and model number of your VAX before calling. VAX Limited, Kingswood Road, Hampton Lovett, Droitwich, Worcestershire WR9 0QH, UK Email: enquiry@vax.co.uk - Website: www.vax.co.uk...