Page 1
Vax Careline: AU: 1300 361 505 NZ: 0800 800 900 Bagless Upright Get Cleaning... What ’ s your Vax ’ s model number? (Located on the top flap of the packaging) What ’ s your serial number? (Located on the base of the machine) Note these down in case you need them in future.
CAUTION: The vacuum cleaner is a very powerful unit. responsible for their safety. Before plugging the cord into the electrical outlet, make sure 6. Use only as described in this manual. Use only Vax the switch is in the ‘off’ position. Hold the vacuum cleaner recommended attachments.
Operation Keep your Vax like new IMPORTANT: The condition of the filters affects the performance of your machine. Please check and clean filters periodically (depending on the level of use). For full cleaning instructions see page 7. IMPORTANT: Do not use the vacuum cleaner without all filters in place.
NOTE: The crevice tool, dusting brush and upholstery tool can all be attached to the telescopic tube or directly to the hose. Attaching the hose Remove hose. Choose an accessory. Turbo tool VARU1200 only. Attach accessory to hose. Vax Service line: AU: 1300 361 505 NZ: 0800 800 900...
Page 7
Attaching the stretch hose (Not standard for all models – VARU1200 model only) Remove stretch hose. Attach stretch hose to the Attach stretch hose to Hose can now be extending existing base hose. telescopic extension tube. for stair cleaning. vax.com.au...
Maintenance (Keep your Vax as good as new) Emptying and cleaning the dirt container Lift off canister. Press the release button on canister to empty. Advanced cleaning Slide out the cyclone separator. Tap over a bin to remove or use a brush to gently excess dirt clean separator.
Maintenance (Keep your Vax as good as new) Cleaning the pre-motor filter Twist canister lid. Lift lid off. Pull out the filter from the canister base. Tap over a bin to remove Wash filter with warm tap water Allow to dry for 24hrs.
Maintenance (Keep your Vax as good as new) Cleaning the post-motor filter WARNING: Do not wash the post-motor filter. Press the release clip at the front on Separate filter from the holder. Tap over bin to clean. the filter cap.
Page 11
Maintenance (Keep your Vax as good as new) Removing debris from brushbar If the light continues to flash after resetting, the brushbar may still be blocked. Using a pair of scissors, cut through any threads or hairs caught around the brushbar. To access brushbar: Press the brushbar reset button again to ensure the blockage is fully cleared.
Page 12
We’re here to help. Simply call us on AU 1300 361 505 or NZ 0800 800 900 What do I do if the unit/accessory or visit vax.com.au becomes damaged or broken? Why won’t the accessory pick The accessory may be blocked;...
8.30am to 5.00pm If you have queries or concerns about using your Vax, call the Vax Careline. Calls are charged at the standard local rate. Please make a note of the serial number and model number of the vacuum cleaner before calling.