Related Manuals for Vax Remo Classic VS-077
Summary of Contents for Vax Remo Classic VS-077
- Page 1 VS-077 easy guide Please read carefully before using your VS-077. Always fully extend mains cable before use.
- Page 2 Important information - Save these instructions Congratulations on the purchase of your VS-077 cylinder cleaner. In order to get the best performance from this product please read and retain these instructions. When using electrical appliances, in order to reduce the risk of fire, electric shock, and/or injury to persons, basic safety precautions should be followed, including the following: •...
- Page 3 How to use your VS-077 Assembling the appliance fig. 1 The telescopic extension tubes can be lengthened by twisting the tubes and pulling. At the required length twist in opposite direction to fix. fig. 2 To attach the flexible hose to the vacuum cleaner, push the connecting end of the flexible hose into the attachment point on the vacuum cleaner.
- Page 4 How to use your VS-077 Adjusting the cleaning tool for carpets & hard floors fig. 3 Hard floor position (tiles, parquet floors, etc.) – The cleaning tool’s brush must be in the lower position. Press on the rocker switch to lower it. fig.
- Page 5 How to use your VS-077 Fully extend the mains cable and plug it into a standard domestic outlet. fig. 5 Press the foot pedal to start the vacuum cleaner. To stop it press the pedal again. fig. 6 Press the foot pedal to recoil the power lead.
- Page 6 How to use your VS-077 fig. 7 Vacuum power can be adjusted electronically by moving the variable power control located on the tube handle. fig. 8 A crevice/dusting multi-tool as shown can be kept on the extension tubes with bracket provided. This attaches directly to the hose or extension tubes.
- Page 7 How to use your VS-077 fig. 9 If you wish to pause briefly during vacuuming i.e. to move a piece of furniture or a rug, use the special parking position on your vacuum cleaner. Slide the hook attached to the large cleaning tool into the slot on the rear of the appliance.
- Page 8 How to care for your VS-077 Your appliance is equipped with a dust bag. If you notice that the vacuum cleaner seems to be less efficient than usual, check the dust indicator by selecting the maximum power and lifting the cleaner tool off the floor. If it turns red, change the bag.
- Page 9 To change the filters Motor protection filter fig. 14 The filter is located in the dust bag compartment and protects the motor from dust. To reach this filter, lift up the grill which secures it and replace it with a new one. Attention: Do not use the vacuum cleaner without the motor protection filter.
- Page 10 Dust bag indicator When the indicator turns red or when the suction power reduces substantially, this indicates that you should change/empty the dust bag. Attention: If after inserting a new dust bag, the indicator stays red, this could be for several reasons: •...
-
Page 11: Replacement Parts
Replacement parts Replacement parts VS-077 – 5 bags Part Number 1-9-125104-00 VS-077 - Cloth bag Part Number 1-9-125106-00... - Page 12 If you have queries or concerns about using your VAX, call the HELPLINE. Calls are charged at the UK national rate. Please make a note of the serial number and model number of your VAX before calling. VAX Limited, Kingswood Road, Hampton Lovett, Droitwich, Worcestershire WR9 0QH, UK Email: enquiry@vax.co.uk - Website: www.vax.co.uk...