Troubleshooting - Polaris Frontier Classic Owner's Manual

TROUBLESHOOTING

M10 Suspension Troubleshooting
Problem
Rear suspension
bottoms too easily
Rides too stiff in
rear
Machine darts from
side to side
Front end pushes
Steering is heavy
118
Solution (perform only one change at a time)
- Increase FRA position (see setup decal under hood for initial
position
- Increase X-over tube length (see setup decal under hood)
- Increase rear track shock coil spring preload
- Increase front track shock coil spring preload
- Change to optional stiff rear track shock compression spring
(see your dealer)
- Revalve rear track shock compression damping
(see your dealer)
- Check track tension
- Decrease FRA position (see setup decal under hood)
- Decrease rear track shock coil spring preload
- Change to optional soft rear track shock compression spring
(see your dealer)
- Revalve rear track shock compression damping
(see your dealer)
- Check track tension
- Make sure skis are aligned properly
- Make sure spindles and all steering components turn freely
- Make sure skags are straight on skis
- Increase IFS preload
- Ensure use of Accu-Trakt dual skags
- Check for worn skags
- Check for binding suspension shafts and grease all pivot points
- Increase front IFS preload
- Shorten front limiter strap
- Check ski alignment
- Check skags and skis for damage
- Decrease IFS preload
- Make sure spindles and all steering components turn freely