Troubleshooting - Polaris ACE 570 Owner's Manual

Drive Belt Wear/Burn
Possible Cause
Driving onto a pickup or
tall trailer in high range
Starting out going up a
steep incline
Driving at low RPM or
ground speed (3-7 MPH)
Insufficient warm-up at
low ambient
temperatures
Slow/easy clutch
engagement
Towing/pushing at low
RPM/low ground speed
Utility use/plowing
Stuck in mud or snow
Climbing over large
objects from a stopped
position
Belt slippage from water
or snow ingestion into the
PVT system
Clutch malfunction
Poor engine performance
Slippage from failure to
warm up belt
Wrong or missing belt
Improper break-in

TROUBLESHOOTING

Use low range during loading.
Use low range. See warnings on page 62.
Drive at a higher speed or use low range more frequently.
Warm the engine at least 5 minutes. With the transmission
in neutral, advance the throttle to about 1/8 throttle in
short bursts, 5 to 7 times. The belt will become more flex-
ible and prevent belt burning.
Use the throttle quickly and effectively.
Use low range only.
Use low range only.
Shift the transmission to low range and carefully use fast,
aggressive throttle application to engage clutch.
WARNING: Excessive throttle may cause loss of control
and vehicle rollover.
Shift the transmission to low range and carefully use fast,
brief, aggressive throttle application to engage clutch.
WARNING: Excessive throttle may cause loss of control
and vehicle rollover.
Dry out the PVT (see page 107). Prevent water from
entering the PVT intake duct (see page 109). Inspect
clutch seals for damage if repeated leaking occurs.
See your POLARIS dealer.
Check for fouled plug or foreign material in gas tank or
fuel lines. See your POLARIS dealer.
Always warm up the belt by operating below 30 mph for
one mile (5 miles or more when temperature is below
freezing).
Install the recommended belt.
Always break in a new belt and/or clutch. See page 52.
Solution
135