TP-Link TL-WR940N Installation Manual page 5

Internet Parameters Configuration
This page will then display.
Click Next
Select
Click Next
Wait for the Router to detect the
connection type.
If PPPoE is detected, the screen will pop up as shown in A. Please proceed to A
If Static IP is detected, the screen will pop up as shown in B. Please skip to B
If Dynamic IP is detected, the screen will pop up as shown in C. Please skip to C.
1. Make sure the cable is securely plugged into the WAN port before
Note
detection.
2. If the connection type your ISP provided is PPTP, L2TP or BigPond (o r
Heart Beat Signal), you must go to "Network > WAN" to configure you r
connection type manually.
A
Configuration for PPPoE
This page will then display.
Enter the Username and
Password provided by your ISP
Click Next
A fter completing the above configuration, please skip to
Configuration.
5
Wireless Settings