Turn on all of your network devices and then check to see if the LEDs of the
Router display normally as the digram below describes.
PWR: Solid light
SYS/WLAN: Flashing
LAN: Flashing or solid light if the
corresponding port is connected
WAN: Flashing or solid light
If the LEDs display abnormally, please check to see if all the cable
Note
connectors (power adapter and Ethernet cable) are well connected to you r
device.
To configure the device, you can either run the Resource CD (method one),
Note
or run the Web-based Quick Setup Wizard (method two). TP-LINK strongly
recommends that you run the Resource CD.
2