Remote Control Unit - Samsung DVD-HR733 Instruction Manual

HDMI (HR738 Only)
No HDMI output.
Check whether the mode is stop
Checkpoint 1
mode or not. You can switch HDMI
mode in stop mode.
Check the Video output is HDMI
Checkpoint 2
enabled.
Check the connection between the
Checkpoint 3
TV and the HDMI jack of the HDD &
DVD RECORDER.
See if your TV supports HDMI.
Checkpoint 4
Abnormal HDMI output screen.
If snow noise appears on the screen,
Checkpoint 1
it means that TV does not support
HDCP (High-bandwidth Digital
Content Protection).
HDMI output Jitter
Check your TV system setup
Checkpoint 1
correctly.
Please refer to the user's manual of
Checkpoint 2
your TV.

Remote Control Unit

The remote control doesn't work.
Point the remote control at the remote
Checkpoint 1
control sensor on your HDD & DVD
RECORDER. Allow for proper
distance. Remove obstacles between
your HDD & DVD RECORDER and
the remote control.
Check whether the batteries are
Checkpoint 2
drained.
Check the TV/DVD selection button
Checkpoint 3
setting.
Check whether TV control button is
Checkpoint 4
selected or not.
Downloaded From Disc-Player.com Samsung Manuals
Other
I forgot my password for parental supervision.
Checkpoint 1
Press and hold the PROG(
buttons on the front panel of the
Recorder for more than 5 seconds
with no disc in the unit. All settings
including the password will revert to
the factory settings. Do not use this
unless absolutely necessary.
(Note that this function is possible
only when no disc is inserted.)
Is it possible to change a subtitle and an audio
signal on a recorded disc?
A recorded disc is played with only
Checkpoint 1
the subtitle and the audio signal
which were selected during recording.
Other problems.
Read the table of contents and then
Checkpoint 1
find and read the section describing
your problem, follow the instructions
given.
Plug your HDD &DVD RECORDER
Checkpoint 2
off and on.
If the problem still persists, contact a
Checkpoint 3
nearby Samsung service centre.
)
English - 123