Two Step Presser Foot Lifter; Changing The Presser Foot; Upper Knife Is Deactivated - JUKI MO-2000QVP Instruction Manual

Using the machine
B
A
C
E
D
Two step presser foot lifter with integrated front
foot lift
To raise the presser foot, lift the presser foot lever on the rear
of the machine, until it engages (A). It can be raised again to
the maximum height and held in this position to provide more
space between presser foot and stitch plate (B).
When the foot is raised (A and B), the front of the foot is auto-
matically lifted.
Note:
When the presser foot is raised, all the tensions are released
making it easier to thread the machine.

Changing the presser foot

Switch the machine off (power switch"0") and deac-
tivate the upper knife.
• Raise the presser foot.
• Turn handwheel towards you until needles are fully raised.
Match the matching up marks on handwheel and side cov-
er.
Press the catch (C) to release the presser foot from the
clamp. Raise the presser foot shank to the highest position (B)
and remove the presser foot to the left. To attach the presser
foot, place it under the shaft. The groove in the shaft should
line up exactly with the presser foot pin (D). Lower the press-
er foot lifting lever and check that the groove in the shank
should line up exactly with the presser foot pin (D). If it is not
lined up, press the catch (C) to line up.
To carry out sewing without cutting the material
(the upper knife is deactivated)
Turn off the power switch before deactivating the
upper knife.
1. Lower the upper knife changeover knob in the direction of
the arrow.
2. Check to be sure that the knife is lowered.
Caution:
To activate the upper knife, bring the upper knife changeover
knob at position E. Turn the handwheel by two revolutions by
hand.
10