TP-Link TL-WR1043ND User Manual page 108

3) Static IPv6
 IPv6 Address - Enter the IPv6 address in dotted-decimal notation provided by your ISP.
 Default Gateway - Enter the default gateway in dotted-decimal notation provided by your ISP.
 MTU Size - The normal MTU (Maximum Transmission Unit) value for most Ethernet networks
is 1500 Bytes. For some ISPs, you may need to modify the MTU. But this is rarely required,
and should not be done unless you are sure it is necessary for your ISP connection.
 Primary DNS - Enter the DNS IPv6 address in dotted-decimal notation provided by your ISP.
 Secondary DNS - Enter another DNS IPv6 address in dotted-decimal notation provided by
your ISP.

Note:
If you get Address not found error when you access a Web site, it is likely that your DNS servers
are set up improperly. You should contact your ISP to get DNS server addresses.
 Address Autoconfiguration Type – RADVD (Router Advertisement Daemon) and DHCPv6
(Dynamic Host Configuration Protocol for IPv6) Server.

Site Prefix Configuration Type - The type of IPv6 address prefix.
Delegated - Get the IPv6 address prefix from the ISP automaticlly, and the device will

delegate it to the LAN.
TL-WR1043ND 450Mbps Wireless N Gigabit Router
Figure 4-104 Static IPv6
-99-