Replacing The Battery Latch Assembly - Dell Vostro 1710 Service Manual

1 battery latch assembly 2 battery release button
3 spring

Replacing the Battery Latch Assembly

CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your
computer.
NOTICE: Ensure the battery latch assembly is properly oriented. The indent for the screw should face up
when installing the assembly.
This procedure assumes that you have completed the removal procedure
1. Ensure that the battery latch spring is properly mounted on the guide post of the battery latch assembly.
2. Align the battery release button with the hole in the battery latch assembly, then press the button into place.
3. Replace the M2 x 3-mm screw that holds the battery release button in the battery latch assembly.
4. Align the guide post on the battery latch assembly with the slot on the base of the computer, then lower the latch
assembly into place.
NOTICE: The battery release button is keyed to ensure proper alignment. If you feel resistance, check the
alignment of the release button.
5. Replace the system board (see
6. Connect the cable that secures the internal card with Bluetooth wireless technology to the system board (see
the Card).
7. Replace the optical drive (see
8. Replace the palm rest (see
9. Replace the display assembly (see
10. Replace the keyboard (see
11. Replace the hinge cover (see
12. Replace the fan (see
Replacing the System Board
Replacing the Optical
Replacing the Palm
Replacing the Display
Replacing the Keyboard).
Replacing the Hinge
Replacing the Fan).
Removing the Battery Latch
Assembly).
Drive).
Rest).
Assembly).
Cover).
Assembly.
Replacing