Replacing The Battery Latch Assembly - Dell Inspiron 9200 Service Manual

2 battery latch assembly
9. Remove the spring from the hook on the bottom panel by lifting it up and away with a screwdriver or a plastic scribe.
1 hook
2 spring
10. Remove the plastic battery latch assembly by twisting the assembly slightly and lifting it out of the channel and away from the bottom panel.
1 battery latch assembly
Replacing the Battery Latch Assembly
1. Insert the plastic latch assembly into the channel on the bottom panel and press into place.
2. Hook the spring over the hook on the bottom panel using a small screw driver or plastic scribe.
3. Place the battery latch release under the bottom panel of the computer and line it up with the hole in the panel, then replace the screw in the assembly.
Ensure that the newly installed latch moves smoothly and freely when pushed and released.
4. Replace the hard drive bay and reinsert the three M2 x 3-mm screws.
5. Replace the system board.
6. Replace the other components removed in
Back to Contents Page
"Removing the Battery Latch Assembly" in reverse order.