Panning Input Channels - Yamaha DM 2000 Owner's Manual

76
Chapter 7—Input Channels
The currently selected Surround mode is displayed in the lower-left corner. When Stereo
mode is selected, the Bus Out routing buttons display numbers from 1 through 8. When a
Surround Pan mode is selected, they display abbreviations of the Surround Channel names,
as shown in the following table. See "Using Surround Pan" on page 77 for more informa-
tion.
Surround Mode
1. Short for LFE (Low frequency Effects).

Panning Input Channels

Input Channels can be panned between the left and right channels of the Stereo Out.
Using the Encoders
1 Use the LAYER buttons to select the Input Channel Layers.
Press the ENCODER MODE [PAN] button to select the Pan Encoder
2
mode.
Use the Encoders to pan the input channels.
3
Using the SELECTED CHANNEL PAN/SURROUND Controls
1 Use the LAYER buttons to select the Input Channel Layers, and use the [SEL]
buttons to select the Input Channels.
Use the Pan control to pan the currently selected Input Channel.
2
The pan display indicates the pan position of the currently selected Input Channel. When
pan is set to center, the center two segments light up. You can use the [L] and [R] buttons
to select horizontal or vertical Input Channel partners.
The [LINK] button, which is enabled only when a Surround mode other than Stereo is
selected, is used to link the Pan control and the Joystick so that either control can be used
for panning. It's a global setting that applies to all Input Channels. For this to work, the
[EFFECT] button indicator must be off and the [GRAB] and [LINK] button indicators
must be on.
Pan Pages
Pan settings can be viewed and set on the Pan pages. If the Auto PAN/SURROUND Display
preference is on, these pages appear automatically when a control in the SELECTED
CHANNEL PAN/SURROUND section is operated. If both the [LINK] and [GRAB] button
indicators are on, these pages will also appear when the Joystick is operated. See "Auto
PAN/SURROUND Display" on page 234.
1 Use the SELECTED CHANNEL PAN/SURROUND [DISPLAY] button to select
the Input Channel Pan pages.
DM2000—Owner's Manual
1 2
Stereo
1 2
3-1
L R
5.1
L R
PAN / SURROUND
L
DISPLAY
ODD
L R
Bus Outs
3 4 5
3 4 5
C S 5
Ls Rs C
R
EVEN
LINK GRAB EFFECT
6 7 8
6 7 8
6 7 8
1
7 8
E