Table of Contents
Advertisement
8D-FB-CV (50 m)
Dimensions in millimeters.
Outer Sheath
Inner Sheath
Armor
50
Cover with heat-shrink tubing and heat.
30
Clamp Nut
Gasket (reddish brown)
Trim shield here.
Insulator
Trim aluminum tape foil here.
Clamp Nut
Solder through the hole.
How to fabricate antenna cable 8D-FB-CV
Remove outer sheath and armor by the
Shield
dimensions shown left.
Expose inner sheath and shield by the
dimensions shown left.
30
Remove insulator and core by 10 mm.
10
Twist shield end.
Slip on clamp nut, gasket and clamp as shown
left.
Clamp
Aluminum Foil
Fold back shield over clamp and trim.
Cut aluminum foil at four places, 90 from one
another.
Fold back aluminum tape foil onto shield and trim.
1
Expose the insulator by 1 mm.
5
Expose the insulator by 5 mm.
Pin
Slip the pin onto the conductor. Solder them
Shell
together through the hole on the pin.
Insert the pin into the shell. Screw the
clamp nut into the shell.
(Tighten by turning the clamp nut. Do not
tighten by turning the shell.)
2. WIRING
2-3
Hide quick links:
Advertisement
Table of Contents
