Rear Panel - Marantz SR-12S1 User Manual

REAR PANEL

z
DIGITAL-OUT
OPT
COAX
RS232C
EXT. IR
OUT
DC OUT 1 DC OUT 2
IN OUT
MULTI
RC
RC-5
Ú9 Ú8 Ú7
Ú6
z DIGITAL INPUT (Dig.1 - 9) / OUTPUT
(coaxial, optical)
These are the digital audio inputs and outputs. There are 5 digital
inputs with coaxial jacks, 4 with optical jacks.
The inputs accept digital audio signals from a compact disc, LD, DVD,
or other digital source component.
For digital output, there is 1 coaxial output and 1 optical output.
The digital outputs can be connected to MD recorders, CD recorders,
DAT decks, or other similar components.
x Preamp Outputs (L, R, SL, SR, SBL,
SBR, C)
When the jumper plugs that link the Amplifier Inputs with these outputs
are removed, these jacks may be connected to an external power
amplifier.
c Subwoofer Output
Connect this jack to the line level input of a powered subwoofer. If an
external subwoofer amplifier is used, connect this jack to the
subwoofer amplifier input. If you are using two subwoofers, either
powered or with a 2 channel subwoofer amplifier, connect a "Y"
connector to the subwoofer output jack and run one cable from it to
each subwoofer amplifier.
v Main Amplifier Inputs
When the jumper plugs that link the Preamp Outputs with these inputs
are removed, these jacks may be used to connect an external source
to the internal amplifiers.
Notes:
• When connecting a equipment, remove the attached jumper
plugs and store them carefully so as not to lose them.
• Only remove the jumper plugs when required. After you finish
using an Main Amp Input jack, replace the jumper plug.
10
x c v b n
PRE OUT MAIN IN
GND
1
L
ANTENNA
2
R
GND
MODEL NO.SR-12S1
3
C
AM
4
SW
R L
5 FRONT
CD
SL (AUX 2)
6 IN
SURR.
SR
TAPE
SURR.
7
OUT
BACK
SBL
IN
SBR
8
CD-R
SUB WOOFER CENTER
/MD
MULTI
9 OUT
OUT
DIGITAL-IN R L 7.1CH-INPUT R AUDIO
Ú5 Ú4 Ú3
m ,
MONI.
2
MULTI VIDEO MONI.
Y
OUT 1
MONITOR
LD CB
OUT
DVD CR
DSS Y
VCR2 /
DSS
DVD - R
IN
TV CB
IN CR
VCR1
Y
OUT
DVD VCR1
IN
IN CB
VCR2/
DVD-R
CR
OUT
L R L VIDEO S-VIDEO COMPONENT VIDEO
Ú2
b FM antenna terminal (75 ohms)
Connect an external FM antenna with a coaxial cable, or a cable
network FM source.
AM antenna and ground terminals
Connect the supplied AM loop antenna. Use the terminals marked
"AM" and "GND". The supplied AM loop antenna will provide good
AM reception in most areas. Position the loop antenna until you hear
the best
n Multiroom Outputs (Audio L&R, Video)
These are the audio and video output jacks for the remote zone (Multi
Room).
Connect these jacks to the optional audio power amplifiers or video
display devices to view and listen to the source selected by the
mulitroom system in a remote room.
m MONITOR OUT
There are 2 monitor outputs and each one includes both composite
video and S-video configurations. When connecting two video
monitors or televisions, be aware that the OSD interface can be used
with both MONITOR OUT.
, COMPONENT VIDEO INPUT/OUTPUT
If your DVD player or other device has component video connectors,
be sure to connect them to these component video connectors on the
SR-12S1. The SR-12S1 has four component video input connectors
to obtain the color information (Y, C
DVD signal or other video component and one component video
output connector to output it directly into the matrix decoder of the
display device.
By sending the pure DVD component video signal directly, the DVD
signal forgoes the extra processing that normally would degrade the
image. The result is vastly increased image quality, with incredibly
lifelike colors and crisp detail.
Notes:
• This component video output is available to OSD menu system.
. Ú0
– + – +
FRONT MULTI
ROOM
LEFT
LEFT
FRONT MULTI
ROOM
RIGHT
RIGHT
SURR.
CENTER
BACK
LEFT
SURR. SURR.
BACK LEFT
IN
RIGHT
SURR.
SPEAKER SYSTEMS
RIGHT
6-8 OHMS
IN
AC IN
Ú1
, C ) directly from the recorded
B R