Brother MFC-790CW Quick Setup Manual page 30

For Wireless Network Users
h
Press TKIP or AES for Encryption Type?
Enter the WPA/WPA2-PSK password you
wrote down in step 15 on page 28 using the
Touchscreen.
You can use the d and c keys to move the
cursor left and right.
The letters appear in this order: lower case and
then upper case.
To enter numbers or special letters, press
repeatedly until the character you want to enter
appears.
(For more information, see Entering Text for
Wireless Settings on page 43.)
Press OK when you have entered all the
characters, then press Yes to apply your
settings. Go to i.
i
Your machine will now try to connect to your
wireless network using the information you
have entered. If successful, Connected will
appear on the LCD for approximately 1 minute.
If your machine does not successfully connect
to your network, verify your network settings
collected in step 15 on page 28 then repeat a
to h to make sure you have entered the correct
information.
If your access point does not have DHCP
enabled you will need to manually configure
the IP address, subnet mask and gateway of
the machine to suit your network. See the
Network User's Guide for details.
Wireless setup is now complete. A four
level indicator at the top of your
machine's LCD will show the wireless
signal strength of your access point or
router.
To install MFL-Pro Suite, continue to
step 17
®
For Windows Users:
Now go to
Page 33
®
For Mac OS Users:
Now go to
Page 37
30