Panasonic CF-29 Series Reference Manual page 58

Multimedia Pocket
Information for the CD Drive
Information for the Second Hard Disk Drive
NOTE
When the computer is on or in the standby or hibernation mode, if the floppy disk drive
is accessed after it had earlier been disconnected, there are instances where the
contents of the floppy disk set prior to the drive removal are displayed.
Do not try to access any of the files. If an attempt is made, an error message may be
displayed or a message prompting you to format the disk may appear. (When this
message appears, select [Cancel] or [No] to close the display.) The above contents
will no longer be displayed when the drive is re-connected or when the computer is
restarted.
When the floppy disk drive is not connected to both the multimedia pocket and parallel
port, do not access the floppy disk drive through Explorer, etc.
The CD drive cannot be used as an external device.
Windows XP
Confirm that [Transfer Mode] is set to [DMA if available] in [Start] - [Control Panel] -
[Performance and Maintenance] - [System] - [Hardware] - [Device Manager] - [IDE ATA/ATAPI
controllers] - [Secondary IDE Channel] - [Advanced Settings] - [Device 0]. Perform this
setting if it has not yet been made.
Windows 2000
Confirm that [Transfer Mode] is set to [DMA if available] in [Start] - [Settings] - [Control Panel]
- [System] - [Hardware] - [Device Manager] - [IDE ATA/ATAPI controllers] - [Secondary IDE
Channel] - [Advanced Settings] - [Device 0]. Perform this setting if it has not yet been made.
Windows XP
To format the second hard disk, perform the operation below.
1
Turn your computer on.
Be sure to log on with the administrator authority.
58