Opd Overfill Protection; Single Cylinder Mounted On A-Frame; Double Cylinder Mounted On A-Frame - Jayco Eagle Owner's Manual

OPD Overfill Protection

Supplied with your folding camping trailer is information that applies to the Type 1
ACME LP Gas Connection on your LP gas tank(s). Please read all information contained
in the supplied literature.
The following instructions will supply information for correct cylinder/valve orientation,
regulator placement, hose length, hose routing and cylinder cover placement. Make sure
these steps are followed for proper LP connections.

SINGLE CYLINDER MOUNTED ON A-FRAME

1. Connect the 3/8" low pressure hose to
the outlet of the two stage regulator.
2. Attach the regulator with the "Z" bracket
on the center of the front wall with the
vent pointing down.
3. Attach the protective plastic cover to the
regulator.
4. The regulator has a 90° elbow that di-
rects the inlet toward the trailer curbside.
5. Place the cylinder on the bracket pro-
vided on the A-frame and position is so
the outlet of the cylinder valve is pointed
directly outward to the curbside wall.
6. If a vinyl cylinder cover is provided, slip it over the cylinder and leave the zipper
open.
7. Attach the 1/4" inverted flare x 24" Type 1 pigtail hose to the regulator inlet and the
right hand swivel nut to the cylinder valve.
8. If applicable, close the cylinder cover zipper up to the hose.
9. Secure the cylinder to the A-frame bracket using the bolts, nuts and washers
provided.

DOUBLE CYLINDER MOUNTED ON A-FRAME

When a second cylinder is installed, a tee
check is used to replace the 90° elbow at the
top of the regulator and another 1/4" inverted
flare x 24" Type 1 pigtail is added. The regu-
lator stays in the original position.
1. Place the second cylinder on the A-frame
bracket so the cylinder valve is pointed
to the roadside of the folding camping
trailer.
2. Secure the second cylinder to the A-
frame using the bolts, nuts and washers
provided.
3. If a vinyl cylinder cover is used, slip it
over the new single cylinder, or a double cylinder cover may be used in lieu of
single covers.
4. Attach the second 24" hose to the tee check on the regulator and the right handed
swivel nut to the cylinder valve.
44