Screen Room Setup - Jayco Eagle Owner's Manual

Fig. 3-15

SCREEN ROOM SETUP

1. The canopy must be setup through step #3 before attempting to attach the screen
room. (See Canopy Setup.)
2. Open, unfold and spread screen room under canopy area. Enclosure must be on the
outside of the twist poles. A grassy area or clean floor is suggested.
3. Each upper side panel has a pocket sewn into fabric. Slide a two-piece tension rafter
into pocket with the white crutch tip to be placed against side panel of the roof.
Insert crutch tip at outer edge, and push in toward unit.
4. Insert peg through the "eye" of the twist pole "B" and then through the hole at the
outer end of end divider bar "C". The white rubber crutch tip will rest against roof
metal or the canopy bag. Install both ends.
5. Attach the Velcro hook sewn to the inner side of canopy to the Velcro loop sewn to
the outer side of the screen room, full length.
6. Wrap lifter post covers around posts and attach with Velcro.
7. Ensure all snaps are secure, fastening skirt to frame of unit.
8. Attach Velcro from skirt to Velcro on screen room lower corners.
9. Adjust three twist poles "B" so bottom of screen room is just touching the ground.
10. Install the 7 stakes through the screen room loops to protect against wind damage.
28