Table of Contents
Advertisement
Problem
Camera turns off without
warning.
Monitor is blank.
Monitor is hard to read.
Date and time of recording
are not correct.
F8
Cause/Solution
• The camera automatically turns off to save power
(auto off function).
• The camera or battery have become too cold and
cannot operate properly.
• The inside of the camera has become hot. Leave
the camera off until the inside of the camera has
cooled, and then try turning it on again.
• The camera turns off if the USB cable connecting it
to a computer or printer is disconnected.
Reconnect the USB cable.
• The camera is off.
• The camera has entered standby mode to save
power. Press the power switch, shutter-release
button, A button, c button, or b (e movie-
record) button.
• The flash lamp flashes while the flash is charging.
Wait for the flash to charge.
• The camera and computer are connected via the
USB cable.
• The camera and TV are connected via an audio/
video cable or HDMI cable.
• Adjust the monitor brightness.
• The monitor is dirty. Clean the monitor.
• If the camera clock has not been set, the "Date not
set" indicator flashes during shooting and movie
recording. Images and movies saved before the
clock is set are dated "00/00/0000 00:00" or "01/01/
2013 00:00" respectively. Set the correct time and
date from the Time zone and date option in the
setup menu.
• The camera clock is not as accurate as ordinary
watches or clocks. Periodically compare the time of
the camera clock with that of a more accurate
timepiece and reset as required.
A
21
F3
–
83, 88,
E25
20
1, 21
49
83, 88
83, E22
78, E73
F6
16, 78,
E71
Advertisement
Table of Contents
