Additional Drivers And Applications; Overview; Setting Up Touchware - Siemens 670 V2 Operating Instructions Manual

2. If your computer has a power switch, turn off the computer unit at the power switch.
3. In order to isolate the power supply completely, turn off the power at the power supply
8.3

Additional drivers and applications

8.3.1

Overview

All of the necessary drivers and applications are contained in the supplied "Documentation &
Drivers" CD.
Caution
Do not turn off the device during the installation of drivers and applications. Otherwise parts
of the software which are necessary for trouble-free operation will be lost.
Note
The supplied drivers and applications have been tested for the system and released for this
device. No warranty can be provided for other software.
The following illustrations of drivers and applications refer to the Panel PC 870 V2. The
corresponding software for the Panel PC 670 V2 differs slightly from these illustrations in
some places.
The 10" key panel is available only on the Panel PC 670 V2.
Press the "Help" button to obtain information concerning the buttons of a dialog.
8.3.2

Setting up touchware

Introduction
The modification of touch pre-settings simplifies operation under Windows. Make user-
specific settings in the touchware using the tab controls "Touch settings" and "Tools."
Panel PC 670 V2/870 V2, Control unit
Operating Instructions, Edition 03/2004, CD Documentation and Drivers
switch and pull out the computer unit plug and the control units plug.
Warning
Always pull out the power supply plug in order to isolate the power to the devices.
On the direct key module, make sure the keys of the membrane keyboard remain
operable until the voltage of the entire device has been switched off.
Operating and parametrizing
8.3 Additional drivers and applications
8-9