Added Third-Party Equipment's Ha Control Function - Yamaha CL5 Supplementary Manual

Added third-party equipment's HA control
function
It is now possible to control supported third-party equipment's head amps (HA) from the
console. You can control HA by registering supported devices in the DANTE SETUP window.
NOTE
While in PREVIEW mode, changes made to HA parameters from the console are not applied to
the device.
You can turn "WITH RECALL" on and off in the REMOTE HA ASSIGN window.
You can store/recall scene libraries and save/load files.
The following third-party products are supported by CL series V3.1:
• Focusrite RedNet 4
• Focusrite RedNet MP8R
You can register up to 8 devices, including R series units. You can also register a device that
has the same UNIT ID as a device that is already registered, including R series units. You can
adjust HA parameters in advance, even when a connection is not established with the device
to be controlled.
You can control the following parameters.
1
2
3
1
HA phantom power (+48V) on/off
2
HA gain
3
Head amp HPF on/off
NOTE
The indicator on the right side of the rack indicates the control status of the device.
Searching for device to be controlled
Connecting to device
Synchronizing with device
Device can be controlled
You can perform the following operations from input channels patched to the target device:
• Store/recall input channel library
• Channel jobs (channel link, etc.)
• HA controls at user level (only when operating HA from an input channel)
• AG-DG LINK
NOTE
You cannot perform this operation on devices that do not support Gain Compensation.
7
I/O Devices window
V3.1 Supplementary Manual