Input Channels; Added Pan Function (Monaural Input Channels Only) - Yamaha CL5 Supplementary Manual

Input channels

Added pan function (Monaural input channels only)

The pan setting for signals sent to the STEREO bus enables you to select PAN LAW settings.
You can select one of the following:
The pan level is nominal at center and +3dB when panned 100%
CENTER NOMINAL
either left or right.
The pan level is -3dB at center and nominal when panned 100%
LR NOMINAL
either left or right.
NOTE
The settings are also applied to the signals sent to the stereo MIX buses
STEP
1. Select a monaural input channel.
2. In the STEREO/MONO field, press a knob to select the channel you want to adjust in
the OVERVIEW window, and then press the knob once again. Or, in the PAN/
BALANCE field, press a knob to select the channel you want to adjust in the
SELECTED CHANNEL window, and then press the knob once again.
3. Use the PAN LAW select button in the TO STEREO/MONO window to set the PAN
LAW for each channel.
.
1
1
PAN LAW select button
This toggle button is used to set the PAN LAW for the Input Channel.
NOTE
PAN LAW settings are also enabled in LCR mode. They are also enabled in Surround mode.
3
For CENTER NOMINAL For LR NOMINAL
Input channels
V3.1 Supplementary Manual