Disassembly Procedure - Yamaha AW2816 Service Manual

DISASSEMBLY PROCEDURE

1. Bottom Cover
(Time required: About 5 minutes)
1-1 Remove the four (4) screws marked [720A] and turn
over the HDD cover, and then pull out the HDD cable
from the connector of the hard disk. The HDD cover
can then be removed with the hard disk. (Fig.1)
When you remove the HDD cover, be sure to
remove it with the hard disk.
1-2 Remove the four (4) screws marked [770]. The
connector cover can then be removed. (Fig.1)
1-3 Remove the two (2) screws marked [720B]. The CD-
RW cover can then be removed. (Fig.1)
1-4 Remove the nine (9) screws marked [700A]. The
bottom cover can then be removed. (Fig.1)
[700A]
〈 Bottom View 〉
[770]
[700A]
CD-RW cover
[720B]
2. SUB-FADER Circuit Board
(Time required: About 15 minutes)
2-1 Remove the eight (8) fader knobs marked [440] and
the fader knob marked [450] from the control panel
side. (Fig.2)
2-2 Remove the bottom cover. (See procedure 1.)
2-3 Remove the four (4) screws marked [700B]. The
SUB-FADER circuit board can then be removed.
(Fig.3)
Bottom cover
[720A]
HDD cover
[700A]
Word direction
Connector cover
[700A]
Fig.1
[410]
[450]
[440]
[700A]: Bind Head Tapping Screw-B
3.0X8 MFZN2BL (EP600190)
[720]: Bind Head Tapping Screw-S
3.0X6 MFZN2BL (EP630210)
[770]: Bind Head Tapping Screw-S
SP 3.0X6 MFZN2BL (V7723000)
[420]
Jog knob
Shuttle knob
Fig.2
[T130]
AW2816
25