Circuit Boards Location - Sony CDX-M630 Service Manual

CDX-M630

4-5. CIRCUIT BOARDS LOCATION

IN SELF SW board
SW board
LOAD-SW board
DISPLAY board
• Waveforms
— Servo Board —
(MODE: CD PLAY)
1
1.8Vp-p
19.9344MHz
IC1 wd (XTAL)
2
5Vp-p
3.3msec
ts (PACK)
IC1
3
1.5Vp-p
(RFO)
IC1 uj
4
0V
Approx. 100mVp-p
IC1 oa (FEO)
5
0V
Approx. 100mVp-p
od (TEO)
IC1
SL SW board
SERVO board
tuner unit
(TU601)
MAIN board
SUB (CD) board
• Waveforms
— Main Board —
(MODE: FM)
1
3.8Vp-p
4.3MHz
IC601 4 (XO)
2
5.4Vp-p
32.768kHz
uf (XOA)
IC801
3
2.6Vp-p
3.68MHz
IC801 os (XO)
4
3.8Vp-p
18.43MHz
IC301 ih (EXTAL)
30
THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is
printed in each block.)
for schematic diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and 1 / W or less unless otherwise
4
specified.
• % : indicates tolerance.
• : internal component.
f
• C : panel designation.
Note:
Note:
Les composants identifiés par
The components identi-
fied by mark 0 or dotted une marque 0 sont critiques
line with mark 0 are criti-
pour la sécurité.
cal for safety. Ne les remplacer que par une
Replace only with part piéce portant le numéro
number specified. spécifié.
• A : B+ Line.
• Power voltage is dc 14.4V and fed with regulated dc power
supply from ACC and BATT cords.
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F : FM
f : AM/MW/LW
J : CD
for printed wiring boards:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
• : parts mounted on the conductor side.
x
• : Through hole.
a
• : Pattern from the side which enables seeing.
(The other layer's patterns are not indicated.)
Caution:
Pattern face side: Parts on the pattern face side seen from the
(Side B) pattern face are indicated.
Parts face side: Parts on the parts face side seen from the
(Side A) parts face are indicated.
30