Cleaning The Motor Protection Filter - Philips FC9269 User Manual

1 Switch off the appliance and remove the mains plug from the wall socket.
 To disconnect the hose, press the release button (1) and pull the hose out of the appliance
() (Fig. 6).
 To unlock the cover, press the cover release button (1). Swing open the cover (). (Fig. 0)
 Lift the dust bucket out of the appliance (Fig. 1).
5 Press the release button for the filter cylinder unit on the bucket handle (1) and remove the
filter cylinder unit (2) (Fig. 32).
6 Hold the dust bucket over a dustbin and empty it (Fig. ).
7 Clean the dust bucket with cold tap water and some washing-up liquid.
8 If you want to clean the filter cylinder unit, remove the filter cylinder from the filter cylinder
case. Turn the handle on top of the filter cylinder anticlockwise (1) and lift the filter cylinder
out of the case (). (Fig. )
9 To clean the filter cylinder, gently tap it against the dustbin to release all fine dust from the
filter cylinder. (Fig. 35)
- If you persistently fail to press the AutoClean button when the light in the AutoClean button
(for types without display) or the AutoClean symbol (for appliance with display) flashes, the
filter cylinder clogs up with dirt and the suction power decreases over time (Fig. 29)
If this happens, unclog the filter cylinder in the following way:
- Hold the filter cylinder over a dustbin and clean it with the cleaning brush supplied. Gently
brush from the top of the filter downwards along the ribs of the filter (Fig. 36).
Only use the cleaning brush that comes with the appliance. Other brushes may damage the filter
cylinder.
The filter cylinder is not waterproof and cannot be cleaned with water, cleaning agents or
flammable substances.
Note: Cleaning does not restore the original colour of the filter, but does restore its filtration power.
10 To clean the filter cylinder case, use a dry cloth or the cleaning brush supplied. You can also
clean it with cold tap water and some washing-up liquid (Fig. 37).
- Do not clean the filter cylinder case with the filter cylinder in it under the tap, as the filter
cylinder is not waterproof (Fig. 38).
11 Put the filter cylinder back into the filter cylinder case (1) and turn it clockwise to fix it (2)
('click') (Fig. 39).
Make sure that the filter cylinder case is dry before you reinsert the filter cylinder into it.
1 Put the filter cylinder unit back into the dust bucket ('click') (Fig. 40).
Make sure that the dust bucket is dry before you reinsert the filter cylinder unit.
1 Put the dust bucket back into the appliance (Fig. 1).
1 Close the cover firmly ('click') (Fig. 42).
Note: If the dust bucket and/or the filter cylinder unit are not installed properly, the appliance does not
work and the standby light on the cover of the appliance flashes.

Cleaning the motor protection filter

Clean the permanent motor protection filter every two months.
1 Unplug the appliance.
English
11