3.
Install the blade holder.
Insert until the
collar is flush with
the surface.
Important Note on the Handling and Use of the Cutting Carriage
Leave the cutting-carriage screw loose when no blade holder is installed. Keeping the screw tightened causes the blade-
holder insertion hole to become gradually smaller, making installation difficult.
Screw
Screw
Support it from below.
Close the front cover, then press
7. Installing the Blade
Loosen the screw shown in the fig-
ure.
Support the screw from below and
insert the blade holder.
Tighten the screw.
Tug the blade holder upward to make sure it does
not come loose.
.
39