Setting Up The Base And Charging Cradle (If Included); Connecting The Base - Siemens GIGASET C595 Manual

First steps

Setting up the base and charging cradle (if included)

The base and charging cradle are designed for use in enclosed dry rooms with
a temperature range of +5°C to +45°C.
¤
Install the base on a level, non-slip surface in a central location in your house
or flat or mount the base or charging cradle on the wall
Please note
Pay attention to the range of the base.
This is up to 300 m in unobstructed outdoor areas and up to 50 m inside
buildings. The range is reduced when Eco Mode (
The phone's feet do not usually leave any marks on surfaces. However, due to
the multitude of different varnishes and polishes used on today's furnishings,
the occurrence of marks on the surfaces cannot be completely ruled out.
Please note:
u
Never expose the telephone to the influence of heat sources, direct sunlight
or other electrical devices.
u
Protect your Gigaset from moisture, dust, corrosive liquids and vapours.

Connecting the base

¤
First connect the
mains adapter 1.
¤
Then connect the
telephone jack
and insert the
cables into the
cable ducts.
Please note:
u
The mains adapter must always be connected, as the phone will not oper-
ate without a mains connection.
u
Only use the mains adapter and phone cord supplied. Pin connections on
telephone cables can vary (pin connections
10
2
1
2
¢
page 79.
¢
page 55) is activated.
1
1
¢
page 74).