Questions And Answers - Siemens GIGASET C595 Manual

Questions and answers

If you have any questions about the use of
your phone, you can contact us 24/7 at
www.gigaset.com/customercare.
The table below contains a list of common
problems and possible solutions.
The display is blank.
1. The handset is not switched on.
¥
Press and hold the end call key a.
2. The battery is flat.
¥
Charge the battery or replace it
¢
( page 12).
Not all menu options are displayed.
The menu display is reduced (Standard
mode).
¥
Activate extended menu display (Expert
¢
mode) ( page 25).
No Base
flashes on the display.
1. The handset is outside the range of the
base.
¥
Move the handset closer to the base.
2 The range of the base is reduced because
eco mode is activated.
¥
Deactivate eco mode (
reduce the distance between the hand-
set and the base.
3. The base is not switched on.
¥
Check the mains adapter of the base
¢
( page 10).
Please register handset
Handset has not been registered with the base
or has been deregistered.
¥
Register the handset (
Handset does not ring.
1. The ringtone is deactivated.
¥
Activate the ringtone (
2. The telephone only rings when the phone
number is transferred.
¥
Activate the ringtone for anonymous
¢
calls ( page 64).
¢
page 55) or
flashes on the display.
¢
page 56).
¢
page 65).
You cannot hear a ringtone/dialling tone
from the fixed line network.
The phone cord supplied has not been used or
has been replaced by a new cord with the
wrong pin connections.
¥
Please always use the phone cord supplied
or ensure that the pin connections are cor-
rect when purchasing from a retailer
¢
( page 10).
Error tone sounds after system PIN prompt.
You have entered the wrong system PIN.
¥
Reset the system PIN to 0000 (
Forgotten the system PIN.
¥
Reset the system PIN to 0000 (
The other party cannot hear you.
You have pressed the mute key h.
The handset is "muted".
¥
Activate the microphone again
¢
( page 30).
The number of the caller is not displayed
despite CLIP.
Calling Line Identification is not enabled.
¥
The caller should ask the network provider
to enable Calling Line Identification (CLI).
You hear an error tone when keying an
input
(a descending tone sequence).
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the user
guide if necessary.
You cannot listen to messages on the net-
work mailbox.
Your PABX is set for dial pulsing.
¥
Set your PABX to tone dialling.
Gigaset C595 only:
No time is specified for a message in the call
list.
Date and time have not been set.
¥
Set the date/time (
The answering machine announces "PIN is
incorrect" during remote operation.
1. You have entered the wrong system PIN.
¥
Enter the system PIN again.
2. The system PIN is still set to 0000.
¥
Change the system PIN (
Service (Customer Care)
¢
page 67).
¢
page 67).
¢
page 15).
¢
page 67).
71