Installing The Head Server; Attaching Sfps; Cabling The Head Server And Disk Enclosure(S) - HP StoreOnce 4900 Backup Installation And Configuration Manual

Installing the head server

1. The label on the top of the HP StoreOnce Backup system contains important information,
including the MAC address and default network name. The label also contains the iLO4
password for the system. Make a note of this information before you install the HP StoreOnce
Backup system in the rack. See also
2. Slide the HP StoreOnce Backup system into position in the rack and secure it to the rack rails
using thumbscrews on the unit's front bezel.

Attaching SFPs

The Accessory Kit supplied with the HP StoreOnce 4900 Backup system contains four 8Gb Short
Wave FC SFP+ and four 10Gb SR SFP+.
Unpack the SFPs and connect them to the corresponding ports on the rear of your product .
Connect an SFP to each FC port and each 10GbE port, as shown below (1).
Figure 8 Connecting FC and 10GbE SFPs on HP StoreOnce 4900

Cabling the head server and disk enclosure(s)

IMPORTANT:
1. There are two power sockets on the head server unit and four power sockets on each disk
enclosure; two to each drawer. Connect each socket to the power supply.
The system will not boot if the SAS cabling is incorrect.
Password best practices (page 34).
Installing the head server 25