Setting Up The Massage Lounger - Panasonic EP-MA70 Operating Instructions Manual

Setting up the massage lounger

1 Where to use the unit
• Ensure there is adequate space to recline.
• Do not expose the massage lounger to direct sunlight or high
temperatures, such as in front of heating sources, because this can
cause discoloration or hardening of the synthetic leather.
• Place the unit on a mat to prevent floor damage.
• When placing a mat under the unit, the size of the mat should be
sufficient (at least 120 cm × 70 cm) to cover the areas where the unit
touches and where the legrest could touch the floor, as shown in the
diagram on the right.
• Install the unit near a power outlet.
See Warning No. 10 and 12 on page 1.
2 Removing everything from the box and installing the unit
Hold onto the sides.
Hold onto the
sides of the
legrest.
Place your
fingers in the
groove
Do not hold onto
the front side.
The sole massage
section might
slide, and injuries
may occur.
Legrest Back cover
9
9-10
Keep at least 10 cm away from the wall.
Approx. 202 cm
Width approx. 95 cm Approx.
30 cm
Approx. 49 cm
Mat Area where legrest Area where unit
could touch the floor touches the floor
• Since the unit is very heavy
(approximately 87 kg), be careful to avoid
back injuries. (The unit must be carried
by two or more persons.)
To put the unit down on the
floor
• Put the unit down slowly and carefully
watch your step.
Groove
• Put down the legrest by holding it with
your hands until it has been set on the
floor completely. If you release your
hands before the legrest is fully
extended, the legrest will forcefully return
to the initial position.
• The floor may get damaged, so it is
recommended to place a mat etc. on the
floor.
See Warning No. 22 and 23 on page 3.
Mat
Confirm that the main unit and the accessories are in the box.
Main unit
Accessories
Armrests (Right/Left) Comfort cushion
Pillow
Right/Left indication
• Small holes on the inside fabric are an intentional
part of the functional design.
Attachment Screws Allen Key Sole Shiatsu Sheet
(M6 × 13) — Black 4 pcs. — 1
(M6 × 20) — Silver 2 pcs.
• This is installed on the sole
(Cross-section)
massage section prior to leaving
4 mm
the factory.
Controller
Controller Stand
Controller Holder
Fixing screw
Clip
Power Cord
Lock Switch Key
— 1
• This is initially inserted in the
lock switch of the power switch
section prior to leaving the
factory.
10
2010/12/28 11:24:30