4. Troubleshooting
4. Troubleshooting
4-1 Failure Display Codes
There is a error code and two kinds of error codes. Possible error codes
during use can be checked before service.
1. Press Clock AM/PM pad.
2. Press Clock AM/PM pad again.
3. Press a number
4. Press Start/Set pad.
5. Press Custom Cook and number 0 pads at the
same time for 2 seconds.
Error codes are displayed.
6. Press number 0 pad, the last 5 error codes can
be checked. But, if the oven turns off, the stored
error codes are deleted.
7. Press Clear/Off pad to return to normal display
mode.
Oven sensor error (Measure or Check tool : Multimeter)
Failure code
E-27
E-28
pad.
CAUSE
Oven sensor opened
Oven sensor shorted.
35
Clock
AM/PM
Start/Set
Custom
Cook
SOLUTION
1. Disconnect power. Open the back cover.
Disconnect sensor harness from control
Measure sensor resistance
sensor.
2. If there is not any problem with oven sensor,
Please check whether there is a damaged
therminal or wire on harness.
3. Check resistance of oven sensor connector on