Dealing With Problems (Advanced); Shutting Down; Battery Indicator - Panasonic Toughbook CF-37 Series Reference Manual

Dealing With Problems
When a problem occurs, refer to this page. If you still cannot troubleshoot the problem, contact Panasonic Technical
Support.
Starting Up
The power indicator or
battery indicator is not lit
is displayed
[POST Startup Error(s)]
is displayed
Windows startup, or an
operation is extremely
slow
The date and time are
incorrect
When the previous item
is not the cause

Shutting Down

Unable to shut down
Windows 98

Battery Indicator

The red indicator lights.
Repeated beeping sound
while the computer is in
use.
The red indicator blinks
After the AC adapter is
connected, the orange in-
dicator blinks five times
Check the cable connection for the AC adapter.
Check to see if a fully charged battery is properly installed.
Remove the battery pack and disconnect the AC adapter, then connect them again.
Input your password. If you have forgotten it, contact Panasonic Technical Support.
page 54
Press F9 in the Setup Utility (
settings to their default values (except the password settings). Then, the Setup Utility
must be run once again for you to input the appropriate operating environment settings.
(The processing speed depends on the application software used, so this operation
may not cause the processing speed to increase.)
You can set the date and time through [Date/Time] in [Start] - [Settings] - [Control
Panel].
When the computer is connected to a Local Area Network (LAN), confirm the
date and time of the server.
If you continue to experience problems, the internal battery maintaining the clock
may need to be replaced. Contact Panasonic Technical Support.
Press F9 in the Setup Utility (
settings to their default values (except the password settings).
In the MS-DOS mode, run SCANDISK to check the hard disk.
At start-up, press and hold Ctrl to operate the computer in the Safe mode.
Try removing all peripheral devices.
If a USB device is connected, try removing it.
The battery level is low. Save your data and power off your computer.
After connecting the AC adapter or replacing the battery pack with a fully charged
one, turn your computer on.
The battery pack or recharging function may be defective. Quickly remove the
battery pack and disconnect the AC adapter, then connect them again.
If the problem persists, contact Panasonic Technical Support.
Unable to charge because of an improper temperature range. (
tions")
(Advanced)
page 45). This will restore the Setup Utility's
page 45). This will restore the Setup Utility's
56
"Precau-