Error Messages - Panasonic KX-TG8522AL Operating Instructions Manual

Useful Information

Error messages

If the unit detects a problem, one of the following messages is shown on the display.
Display message
Base no power
or
No link to base.
Reconnect main
base AC adaptor.
Check Phone Line
Error
Failed
Incomplete
Memory Full
Use rechargeable
battery.
You must first
subscribe to
Caller ID.
46
Cause/solution
L The handset has lost communication with the base
unit. Move closer to the base unit and try again.
L Unplug the base unit's AC adaptor to reset the unit.
Reconnect the adaptor and try again.
L The handset's registration may have been cancelled.
Re-register the handset (page 30).
L The supplied telephone line cord has not been
connected yet or not connected properly. Check the
connections (page 8).
L Recording was too short. Try again.
L Phonebook copy failed (page 20). Confirm the other
handset (the receiver) is in standby mode and try
again.
L The receiver's phonebook memory is full. Erase the
unwanted phonebook entries from the other handset
(the receiver) and try again.
L The phonebook memory is full. Erase unwanted
entries (page 19).
L Message memory is full. Erase unwanted messages
(page 38, 39).
L The call barred list memory is full. Erase unwanted
entries (page 29).
L The maximum number of base units (4) is already
registered to the handset. Cancel unused base unit
registrations from the handset (page 31).
L A wrong type of battery such as Alkaline or
Manganese was inserted. Use only the rechargeable
Ni-MH batteries noted on page 4, 6.
L You must subscribe to a Caller ID service. Once you
receive caller information after subscribing to a Caller
ID service, this message will not be displayed.