Panasonic KX-TG8522AL Operating Instructions Manual page 28

Programming
L You can select 24-hour or 12-
hour clock format ("AM" or "PM")
by pressing /.
4
Enter the desired hour and minute
you wish to end this feature. i
M
5
{ic}
L When the night mode is set, 3 is
displayed.
Note:
L To correct a digit, press {<} or {>} to
move the cursor to the digit, then
make the correction.
Changing the start and end time
1
1 (centre of navigator key) i
{#}{2}{3}{7}
2
Continue from step 3, "Turning night
mode on/off", page 27.
Setting the ring delay
This setting allows the handset to ring
during night mode if the caller waits long
enough. After the selected amount of
time passes, the handset rings. If you
select "No Ringing", the handset
never rings during night mode.
1
1 (centre of navigator key) i
{#}{2}{3}{9}
2
{V}/{^}: Select the desired setting.
i M i {ic}
Note:
L When the answering system answers
the call, this feature does not work.
Selecting categories to bypass night
mode
1
1 (centre of navigator key) i
{#}{2}{4}{1}
2
{V}/{^}: Select your desired
categories. i t
L "Q" is displayed next to the
selected category numbers.
28
L To cancel a selected category,
press t again. "Q" disappears.
3
M i {ic}
Note:
L You can also select the categories in
step 2 as follows:
Press {1} to {9}. i M
Changing the handset name
Each handset can be given a
customised name ("Bob", "Kitchen",
etc.). This is useful when you make
intercom calls between handsets. You
can also select whether or not the
handset name is displayed in standby
mode. The default setting is "Off". If
you select "On" without entering any
handset name, "Handset 1" to
"Handset 6" is displayed.
1
1 (centre of navigator key) i
{#}{1}{0}{4}
2
Enter the desired name (max. 10
characters; page 44).
L If not required, go to step 3.
3
M
4
{V}/{^}: Select the desired setting.
i M 2 times
5
{ic}
Storing an area code to be
deleted automatically
In some situations, phone numbers
stored automatically in the caller list
(page 34) will include area codes. If you
do not want to dial the area code when
making calls from the caller list, you can
store the area code which you want the
unit to delete automatically.
Example: You have stored the area
code "123". If you make a call from the
caller list to the phone number "123-456-
7890", the unit dials "456-7890".