Philips PT927 User Manual page 13

using the Jet Clean system
1 Place the shaver without protection cap upside down in the shaver
holder. Push down the locking lever completely to lock the shaver
into place.
The battery symbol on the Jet Clean System goes on to indicate that
,
the shaver is being charged.
Note: The shaver cannot be placed in the Jet Clean System when the protection
cap is on the shaving unit.
2 Press the on/off button on the Jet Clean System to start the cleaning
program.
The battery symbol on the Jet Clean System goes out.
,
During the cleaning program, the cleaning symbol starts to flash and
,
the shaver is automatically lowered into the cleaning fluid.
The shaver automatically switches on and off several times
,
and moves up and down.
The cleaning symbol flashes throughout the cleaning program, which
,
takes approx. 8 minutes.
After the cleaning program, the battery symbol on the Jet Clean
,
System goes on to indicate that the shaver is being charged.
Note: If you press the on/off button of the Jet Clean System during the cleaning
program, the program aborts and resets. In this case, the cleaning stops
flashing and the shaver holder returns to its starting position. The shaver may
still be wet and dirty, because the cleaning program has not been finished.
Note: If you remove the adapter from the wall socket during the cleaning
program, the program aborts. The shaver holder remains in its current position.
When you put the adapter back into the wall socket, the shaver holder moves
to its highest position.
Note: When the fluid level drops below the minimum level, the cleaning symbol
and the 'fluid low' symbol start to flash with intervals and the shaver holder
returns to its starting position
Cleaning the Jet Clean system
Empty the cleaning chamber and clean it thoroughly by rinsing it with hot
tap water every 15 days if you use the Jet Clean System daily. Otherwise
empty and clean the cleaning chamber at least once a month.
1 Clean the outside of the Jet Clean System with a moist cloth.
Never immerse the Jet Clean System in water, nor rinse it under the tap.
2 Simultaneously press the release buttons on both sides of the Jet
Clean System (A). Then lift the Jet Clean System off the cleaning
chamber (B).
The cleaning chamber remains behind.
,
English
13