Names Of Parts - Zoom tac-8 Operation Manual

Names of Parts

Front Panel
Level indicators
The LED lights red when the
signal clips.
Hi-Z switches
Use to switch the input
impedances of inputs 1 and 2.
Turn them on when connecting a
guitar or bass guitar.
XLR
2 1
1：GND
2：HOT
3 3：COLD
04
Input gain knobs
Use to adjust the input gain of
the mic preamp.
PHANTOM switches
Set these to on to supply
phantom power to inputs 1–4 and
5–8.
TRS
TIP：HOT
RING：COLD
SLEEVE：GND
INPUT jacks
These analog signal input jacks have mic preamps.
You can connect mics, keyboards and guitars to them.
These can be used with both XLR and 1/4-inch
(balanced or unbalanced) phone plugs.
Inputs 1 to 8
CLOCK SOURCE
indicators
These show the clock source
that is being used: ADAT,
S/PDIF , WORD CLOCK or
INTERNAL.
Standalone mode
In standalone mode, the
and digital input/output device without being connected to a computer.
When used in standalone mode, operation is set in advance using the
mixer application.
Power indicator
This lights when the
turned on.
PHONES 1 and 2 volume knobs
Use these to adjust the
headphone volumes of the
PHONES 1 and 2 jacks.
PHONES 1 and 2 jacks
Connect headphones to these.
MAIN OUTPUT level knob
Use to adjust the volume of
the audio signal output from
the MAIN OUTPUT jacks.
can be used as an eight-channel mic preamp
is