Finishing; Glass Door Removal; Crystal Ember Installation - Napoleon EFL42S Installation And Operating Instructions Manual

4.0 FINISHING

POWER SUPPLY SERVICE MUST BE COMPLETED PRIOR TO FINISHING TO AVOID
4.1

GLASS DOOR REMOVAL

FACING AND/OR FINISHING MATERIALS MUST NOT INTERFERE WITH AIR FLOW THROUGH AIR
OPENINGS, LOUVRES OPENINGS, OPERATION OF LOUVRES OR DOORS OR ACCESS FOR
SERVICE. OBSERVE ALL CLEARANCES WHEN APPLYING COMBUSTIBLE MATERIALS.
BEFORE DOOR IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL
TO THE TOUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.
A. Remove the 4 screws, as shown in the illustration below.
B. Tilt the top of the door forward until you can hold the sides of the door. Lift the door up and out of the
bottom retainer.
4.2

CRYSTAL EMBER INSTALLATION

Glass front must be removed and the appliance must be mounted in its fi nal location before the crystal embers
are installed.
A. CLEAN CRYSTAL MEDIA: Crystal media may have a fi ne oil
residue that needs to be cleaned prior to installation. Clean the
crystal with mild dish soap, drain, rinse thoroughly and dry before
placing into the tray.
B. Carefully place crystal embers into the bottom tray on the front of
the appliance as illustrated. Apply an even layer from side to side.
RECONSTRUCTION.
AIR OPENINGS CANNOT BE COVERED IN ANY CIRCUMSTANCES.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
WARNING
!
WARNING
!
13
EN
W415-1142 / E / 07.13.15