Configuring Switches And User Access To Target Devices - Fujitsu control 4 0812 User Manual

2. Installation and startup
2.5 Configuring switches and user access to target
devices
This section provides an overview of configuration steps. Details are provided in
other chapters.
For switch-specific information, see the Installation and User's Guide for the
switch.
To add switches, complete the following steps:
1. Install the KVM s4 client software on one or more client computers.
2. Open the software on a client computer.
3. Use the Explorer to set unit properties, options, and other customization as
needed.
4. Configure the names of all target devices using the local GUI interface.
5. Repeat steps 3 through 6 for each switch you want to manage.
6. After one software environment is set up, select File-Database-Save to save
a copy of the local database with all the settings.
7. From the software on a second computer, select File-Database-Load and
browse to find the saved file. Select the file and then click Load. Repeat this
step for each client computer that you want to setup.
8. To access a target device attached to an switch, select the target device in
the Explorer and click the Connect Video or Browse button to open a session
(only the corresponding button for the selected target device is visible).
You can configure user accounts either through the software or through the
switch integrated Web interface.
For how to use the Web interface to create user accounts, see the KVM s4 Switch
Installation and User's Guide.
To configure a switch, complete the following steps:
1. Connect a terminal or PC running the terminal emulation software to the
configuration port on the back panel of the switch using the supplied serial
cable. The terminal should be set to 9600 baud, 8 bits, 1 stop bit, no parity,
and no flow control.
2. Plug the supplied power cord into the back of the switch and then into an
appropriate power source.
12
590-1059-640A