Installing The Transducer; Transom Mount Installation - Garmin Fishfinder 250 Owner's Manual

G S > I
ETTING TARTED NSTALLATION

Installing the Transducer

Proper transducer installation is key to getting the best performance
from your new unit. If the transducer lead is too short, extension
cables are available from your Garmin dealer. Coil and secure any
excess cable. DO NOT cut the transducer lead or any part of the
transducer cable, as this will void your warranty. The cable cannot
be spliced and connected to any existing (Garmin or non-Garmin)
transducer cables.
Following are some tips and basic installation instructions for
some popular transducers. Detailed installation instructions are
provided in the transducer kits. Some transducers may need to be
installed by a professional marine installer.

Transom Mount Installation

Transom Mount Transducer (depth/temp)
NOTE: DO NOT mount the
transducer behind strakes,
struts, fittings, water intake or
discharge ports, or anything that
creates air bubbles or causes the
water to become turbulent. It is
important that the transducer be
in clean (non-turbulent) water
for optimal performance.
10
����� ������ ������� �� ���
����� ������� �� ������� �����
���� ������� ���� ��� ��������
��
����� ��� ���������� �������� ���� ��� �������
To Unit
��� �������
Speed
Connecting a Transducer
to Multiple Sensors
����� ��� ���������� ����� �����
���� ����� ��� ����������
��� ���������� ������ ������ ���� ����� ����� �
���������� ���� �� ���� ������ ����� �� �������� �����
���� ���� ���� ��� ���������� ��
����� ����� ����� ���� ��� ����
�� �� ����� �� ���� ������
�� ��� ����� ��� ���������� �������� �� ���
���� �� ��� ����� ��� ���������� ��� �����
���������� ���� ��� ������� ��� ������ �����������
��� ������ ��� �����
Fishfinder 250/250C Owner's Manual
Temp Transducer