Dell poweredge t330 Owner's Manual page 142

4. Place the system on a flat and stable surface.
5. If installed, remove the system feet or caster wheels.
6. Remove the system cover.
Steps
1. Remove the control panel assembly from the chassis.
2. Remove the control panel assembly cover.
3. Install the VGA module.
4. Install the control panel assembly cover for rack mode into the control panel assembly.
5. Remove the system top cover.
6. Install the control panel assembly for rack mode into the chassis.
7. To attach the rack ears, complete the following steps:
a. Align the screw holes on the right rack ear with the screw holes on the right side of the rack
system.
b. Install the screws using a Phillips #2 screwdriver.
Figure 60. Removing and installing the rack ears
1. front panel
3. screw for each rack ear (3)
Next steps
1. Install the system cover.
2. Install the system in a rack. For more information, see the system's Rack Installation Guide at
Dell.com/poweredgemanuals.
142
2. rack ear (2)